TM-D710A and UI-View32


I was able to interface my TM-D710A with UI-View32. Previously I was using UI-View32 along with a Kantronics KPC-3+ and a dedicated FM rig (FT-1500) with a direct packet connection. This set up worked well – UI-View32 puts the KPC-3+ into KISS mode and the rest of the settings are pretty straight forward. The advantage of using the TM-D710A (one of many) is that with its two radios in one I can run my APRS station and also get on the local repeaters while only using my one VHF/UHF antenna.

I use Weather Display in conjunction with my Davis Vantage Pro2. Weather Display is an amazingly powerful application and it works well with UI-View32, allowing my APRS station to transmit my weather data in addition to my position info.
Configuring TM-D710A and UI-View32 to work together is little more tricky.
The TM-D710A has a built-in TNC. When you use the TM-D710A in a mobile configuration, the TNC runs in APRS mode. When used with UI-View32, the TNC operates in standard packet mode. It looks like it is possible to use the TNC in KISS mode, but I am not sure how to do that with UI-View32. The directions from Kenwood for the TM-D710A include a recommended CMD file to be used with UI-View32. I used the recommended CMD file and UI-View32 and the TM-D710A worked together up to a point. What was missing were two TNC commands that allow UI-View32 to see the received APRS traffic and then display the traffic on the UI-View32 map. Here is what the CMD file looks like now:

;This is a sample TNC initialization file for use with
;the Kenwood TM-D710A.

[SETUP]
;DON’T alter anything in this section unless you are
;sure you know what you are doing!
COMMAND_PROMPT=cmd:
COMMAND_CHARACTER_CODE=3
ESCAPE_CHARACTER_CODE=
CONV_COMMAND=CONV
MYCALL_COMMAND=”MYCALL ”
UNPROTO_COMMAND=”UNPROTO ”
NO_BEACON_COMMAND=BEACON EVERY 0

[INIT_COMMANDS]
^C^C^C
;Control mode on.
TC 1!TS 1
;Select TNC PKT mode on A band.
TN 2,0!TN 2,0
;Waiting for command prompt.
^M!cmd:!5
;Repeating the first two commands is not an error!
ECHO OFF
BEACON EVERY 0
ECHO OFF
BEACON EVERY 0
;Also UI-View32 to see incoming APRS traffic
MON ON
MCOM ON